Top mount position

louishamilton310 · Oct 3, 2025

Morning everyone!

please can someone double check the position of the top mount bearing before I tighten up the nut

I believe the notch on the bearing is meant to line up with the back of the shock

I can’t find much online about it, the workshop manual just says to keep a note of the original position but I don’t have anything to reference as I was previously on coilovers

thanks!

teflonbilly · Oct 3, 2025

That looks ok, as long as both ends of the spring are fully seated against the stops it should be fine.

Bigayal · Oct 3, 2025

The mount only fits in one way I think and then once in position can only fit in the knuckle one way with the guide bar at the back

snowblind · Oct 3, 2025

louishamilton310 · Oct 3, 2025

Perfect thanks a lot for the advice guys 🙂

Top mount position

Attachments

Our Vendors

Top Contributors this Month

Recommended Communities