Ford Focus ST Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter · #1 ·
strongly thinking about change my clutch and flywheel for rs one, anyone got any advise and also is it just unbolt st clutch and bolt rs one in nothing else needed??

also anyones whos got one would be interest to hear what u think of them got a price of £870 from my local ford dealer, which i didnt think was bad???

many thanks adam
 

·
Banned
Joined
·
6,700 Posts
QUOTE(Simo @ 4 Feb 2010, 08:43 PM) <{POST_SNAPBACK}>Is that fitted? If so it's a great price.

If it's just supplied then it's ****
Check the posts on here for all the parts you need to change - I'm sure it's usual to fit the RS slave cylinder and one or 2 other bits too.

I think the nearest thing to a downside with it is the RS clutch feels slightly heavier but this must be a minor gripe at most.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top