[MatST-3]

hi al

yesterday i had some fault codes come up on my dash

they was acceleration reduced and engine fault,now i have sorted the the problem it was a pipe had come off where i had forgot to do it up

.
was in the car today and it now doesnt rev over 3 1/2 revs which im sure is what it revs to on the standard map however im sure with the map on it revs alot higher is this right?? or will the faults that came up still be active and need wiping??

thanks

 

[Chris]

Try removing fuse 26 and leave it out for a couple of hour's then replace

 

[MatST-3]

QUOTE(Chris @ 7 Feb 2010, 09:59 PM) <{POST_SNAPBACK}>Try removing fuse 26 and leave it out for a couple of hour's then replace

What will that do?? will it reset the faults??

 

[DaveCHCI]

QUOTE(MatST-3 @ 7 Feb 2010, 10:08 PM) <{POST_SNAPBACK}>What will that do?? will it reset the faults??

It resets the cars Keep Alive Memory. Should clear any fault codes that are no longer valid.

 

[Chris]

 

[MatST-3]

QUOTE(Chris @ 7 Feb 2010, 10:15 PM) <{POST_SNAPBACK}>

would it do the same thing if i disconnect the battery?

 

[troy45]

QUOTE(MatST-3 @ 7 Feb 2010, 10:18 PM) <{POST_SNAPBACK}>would it do the same thing if i disconnect the battery?
It would but then you'll have to re-enter your radio code and a few of your radio settings may go astray too.

Pulling Fuse 26 in the engine bay fuse box is a doddle so try that first