Ford Focus ST Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
195 Posts
Discussion Starter · #1 ·
Hi guys

I've just purchased a replacement glove box lid, to replace my current scratched one, just wondering is there a workshop manual on the forum, to show how to fit this, or better still has anyone replaced one?

Nige
 

·
Registered
Joined
·
2,925 Posts
To replace this you have to take out the glove box liner it is held in by 7 torex screws iirc you need a T30 torex bit. You will see the 4 screws along to top when you open the glove box but the bottom 3 are hidden behind covers, just push down on them and they pop free. Before you pull the glovebox fully out check the top left hand corner as there might be a wire attached to it. When you have the glovebox out you will see a arm on the right hand side this just clips on to the door and just pulls off, after that the door pulls off as it is only held in by clips.
 
1 - 2 of 2 Posts
Top