Ford Focus ST Forum banner
1 - 19 of 19 Posts

·
Administrator
Joined
·
12,104 Posts
Discussion Starter · #6 ·
It's post face lift so it looks as though you have to remove the headlight unit as you can't get rear access.
 

·
Registered
Joined
·
1,368 Posts
I think it's the same principle as pre facelift. Cover on the back with 4 clips to pop off and cover will reveal bulb holders(somestimes there is a mini torx screw also holding this cover), yes headlight will need to come out.

beaten to it
 

·
Registered
Joined
·
10,290 Posts
Remove headlight using torx screw and pushing down the clips.
Move headlight so you can get to the back.
Remove the rubber cover.
Depending on it you have xenons or normal bulbs depends on the next bit.
 

·
Administrator
Joined
·
12,104 Posts
Discussion Starter · #12 ·
How many torx screws are there and where are the clips?

I can ony see one torx and can't see the clips.
 

·
Registered
Joined
·
10,290 Posts
How many torx screws are there and where are the clips?

I can ony see one torx and can't see the clips.
Look down on top of the healight.
Underneath there is a long black prong that just needs pushing down with your finger or a screwdriver.
 

·
Administrator
Joined
·
12,104 Posts
Discussion Starter · #16 ·
Andy, superb, thank you.... Even in the dark by dodgy torchlight with your video I was able to find both the clips and remove headlight!

Shame I then found out I'd not got the right bulb........
 

·
Administrator
Joined
·
12,104 Posts
Discussion Starter · #18 ·
Just to close this one off... Went to Halfrauds today and bought new bulb (actually bought 2 as they're bogof), mrs m came home after dark and I fitted new bulbM
 
1 - 19 of 19 Posts
Top