Ford Focus ST Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2,967 Posts
Discussion Starter · #1 ·
Thought it was time for a change, so i ordered a set of fading ST side stripes from DMB.

Now is it better to fit the full stripe in one go or fit the two sections seperately as the side skirt looks as if it ever so slightly kicks up toward the rear, and with the stripe
sitting about 5mm above the skirt i'm unsure to which would look correct.

Any help would be appreciated.
 

·
Registered
Joined
·
1,437 Posts
I did one side all in one go, and the other in 2.

The one done all in one looked much better.... the small part of the one we did seperately was wonky... take plenty of time,

My tactic was using lots of water underneeth, and 'smoothing' it out with a window scraper.

Good luck.
 

·
Registered
Joined
·
2,967 Posts
Discussion Starter · #3 ·
QUOTE(kosmo @ 18 Nov 2009, 10:38 PM) <{POST_SNAPBACK}>I did one side all in one go, and the other in 2.

The one done all in one looked much better.... the small part of the one we did seperately was wonky... take plenty of time,

My tactic was using lots of water underneeth, and 'smoothing' it out with a window scraper.
Good luck.

Cheers fella.


Any others?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top