Ford Focus ST Forum banner

Dsci Induction Kit & Rs Ecu Cover

223 Views 5 Replies 6 Participants Last post by  Tall Person
Just wondered if any of you out there had fitted the DSCI induction Kit to your car and instead of relocating the
ecu to behind the headlamp, have used the RS ecu cover? so putting it where it sits on the RS. If so any pics
and was it easy?
1 - 6 of 6 Posts
QUOTE(bully09 @ 4 Dec 2009, 09:31 AM) <{POST_SNAPBACK}>Just wondered if any of you out there had fitted the DSCI induction Kit to your car and instead of relocating the
ecu to behind the headlamp, have used the RS ecu cover? so putting it where it sits on the RS. If so any pics
and was it easy?

Yes it has been done mate.

http://www.teamtorquesteer.co.uk/underbonn...-ecu-cover.html
Ive seen one done in the flesh and must admit it looks quite snazzy. I will be doing it myself when i can be bothered lol.
QUOTE(Shaggy @ 4 Dec 2009, 01:19 PM) <{POST_SNAPBACK}>Ive seen one done in the flesh and must admit it looks quite snazzy. I will be doing it myself when i can be bothered lol.

Me too, most likely in the new year


The wire trapped between the ECU and lower pipe bugs me.
See less See more
QUOTE(Mick @ 4 Dec 2009, 03:23 PM) <{POST_SNAPBACK}>Me too, most likely in the new year


The wire trapped between the ECU and lower pipe bugs me.

Mick - I did this conversion on mine. Definitely worth the extra money, it looks like OEM and is practical, keeping the ECU protected. I undid the jubilee clip on the top radiator hose and managed to bend the hose around the loom and push it back on the radiator. I lost less than a cup of water, then no more came out, so I did it at my leisure. Obviously the car was on a level and engine cold, but there was certainly no need to drain the system down.....
See less See more
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top