Ford Focus ST Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
689 Posts
Discussion Starter · #1 ·
I've just bought some new alloys for my
but the Ford lock nut removal tool is very tight in the hole, Does anyone know of any lock nuts that have a slightly narrower fitting removal tool?

PS the actual wheel nuts are the same size as the standard Ford ones.
 

·
Registered
Joined
·
24,177 Posts
QUOTE(Jackal @ 20 Jan 2010, 12:52 AM) <{POST_SNAPBACK}>I've just bought some new alloys for my
but the Ford lock nut removal tool is very tight in the hole, Does anyone know of any lock nuts that have a slightly narrower fitting removal tool?

PS the actual wheel nuts are the same size as the standard Ford ones.

Ello matey! Hope all is good over on the island! You could try the McGard 24137, they are a bit longer than the standard fitment ones so dont need the key to go so far into the recess! These are the ones you need if you fit wheel spacers that have slightly longer studs!
 

·
Registered
Joined
·
689 Posts
Discussion Starter · #3 ·
Cheers mate, sounds exactly what I'm after.
All good over here, weather is like it was during your last visit
 
1 - 4 of 4 Posts
Top